Alabama permit test practice

What is the purpose of large flashing or sequencing arrow panels in a work zone?

1. ATo indicate the work zone speed limit numerically
2. BTo guide drivers into lanes and show the road ahead is closedCorrect
3. CTo replace the need for any other warning signs
4. DTo mark the location of flag operators only

Why: Flashing arrow panels may be used in work zones to guide drivers into certain lanes and inform them that part of the road is closed.

When approaching a road construction area, what should a driver be on the lookout for?

1. AA reduced number of warning signs compared to normal roads
2. BNo changes to normal driving behavior
3. CA flagman, one-way traffic, or other obstructionsCorrect
4. DFree parking areas set up for workers

Why: You are about to enter a road construction area and should watch for a flagman, one-way traffic, other signs, or obstructions.

When meeting or following a stopped school bus with its stop signal arm extended and red lights flashing, what must a driver do?

1. AProceed slowly past the bus once children are no longer visible
2. BWait 10 seconds and then proceed regardless of the lights
3. CRemain stopped until the stop arm retracts and the red lights turn offCorrect
4. DOnly stop if approaching the bus from behind, not when meeting it

Why: When meeting or following a stopped school bus with the stop signal arm extended and flashing red lights, remain stopped until the arm is retracted and the lights are off.

To avoid stalling while crossing railroad tracks, what should a driver avoid doing?

1. AKeeping both hands on the wheel
2. BChanging gears while crossing the tracksCorrect
3. CChecking mirrors before crossing
4. DSignaling before the crossing

Why: To avoid stalling, a driver should not change gears while crossing the track.

At what speed does partial hydroplaning typically begin for a standard passenger car on wet roads?

1. AAbout 15 mph
2. BAbout 35 mphCorrect
3. CAbout 65 mph
4. DAbout 80 mph

Why: In a standard passenger car, partial hydroplaning starts at about 35 mph and increases with speed.

What is the correct hand signal for a driver intending to stop or decrease speed?

1. AHand and arm extended straight out
2. BHand and arm extended downwardCorrect
3. CHand and arm extended upward
4. DA closed fist held at chest level

Why: The correct hand signal for stopping or decreasing speed is the hand and arm extended downward.

If your headlights suddenly fail while driving at night, what should you try?

1. AFlashing the high beams repeatedly until they reset
2. BYour parking lights and directional signals as a backup light sourceCorrect
3. CPulling the fuse box cover to reset the system
4. DTurning the ignition off and on rapidly while moving

Why: If your headlights suddenly fail, try your parking lights and directional signals — one of the two may work and give you enough light to guide you off the road.

Where should a driver avoid passing a bicyclist due to limited visibility?

1. AOn a straight, flat road with a wide shoulder
2. BUphill or on a curve where visibility is limited or obstructedCorrect
3. CAnywhere the speed limit is posted under 30 mph within town limits
4. DOn roads with a marked bicycle lane

Why: Drivers should avoid passing a bicyclist when traveling uphill or in a curve, or in areas of limited or obstructed visibility.

Does Alabama's GDL (Graduated Driver License) law apply to individuals 18 years of age or older?

1. AYes, it applies until age 21
2. BNo, it does not apply to individuals 18 or olderCorrect
3. CYes, but only for the first year after turning 18
4. DYes, it applies to all licensed drivers regardless of age

Why: The GDL summary states the law does not apply to individuals 18 years of age or older.

How many points does a speeding violation of 26 mph or more over the limit carry?

1. A2 points
2. B5 pointsCorrect
3. C3 points
4. D4 points

Why: Speeding 26 mph or more over the speed limit carries 5 points, compared to 2 points for lesser speeding violations.